I am not able to connect to ECU via Diagnostic at all therefore i cant read any DTCs.īefore flashing car was starting fine, no problem with ECU or Immo. ![]() The key symbol light in the dashboard is blinking really fast which it never did before. Then i installed it back in the car and went on with starting the car but no start at all !?!? It cranks but no start as if the immo would be on?! I took the ECU off the Car, desoldered my wire and put it all back together. I started the car right up and it idled fine! I let it run for about 10 seconds and turned it off as i wanted to put the ECU back together. MPPS asked me to turn off ignition and turn it back on and this is what i did. I wrote Flash while ECU was still connected to the Car and it was all fine! Checksum was also ok regarding MPPS Software I read ECU with MPPS without any Problem, after that i modded the Original File with ECUSafe and wrote it back to the ECU via OBD using Bootmode. I did this by soldering a wire and using a 1k Ohm Resistor. So i went on with downloading MPPS Software, ECUsafe and i put the ECU into Bootmode by putting a Pin from 29F400 to Ground, while connected to car. The car had IMMO OFF done before, not by me Its a Peugeot 307 2.0 HDI 107 HP year 2002 ![]() ![]() I got my MPPS China v16 today and i wanted to turn DPF and EGR off on my Peugeot
0 Comments
Leave a Reply. |